Table of Contents
Advertisement
Brought To You By Augusta Flint
12.
Locate the Top Plate (1A). Attach the Top Plate to the two Reinforce Plates (3A) at
the top of the Stand. To do so, insert four Screws (16A) through the holes in the Top
Plate and through the holes located at each end of the Reinforce Plates. Secure the
Top Plate to the Reinforce Plates using eight Screws (16A), eight Washers (18A),
and eight Nuts (19A). (See Assy. Diagram.)
13.
Turn the Stand upside down, and attach the Rubber Feet (22A) assemblies to each
of the four corners of the Stand. (See Assy. Diagram.)
14.
Turn the Stand right side up. Check to make sure the Stand is setting square on the
floor. Then wrench tighten all Screws and Nuts securely throughout the Stand.
15.
Attach the Left Protect Plate (28A) to the left side of the body of the Stand, using
the Stop Blocks (27A) and Screws (35A). (See Assy. Diagram.)
TO ATTAcH THe JOINTeR TO THe STAND
1.
Open the panel on the Left Protect Plate (28A), and temporarily set it aside.
(See Assy. Diagram.)
2.
Locate the Front Table (2) and Rear Table (3) assembly. (See Assy. Diagram.)
3.
With assistance, place the Front and Rear Table (2, 3) assembly on the Top Plate
(1A). (See Assy. Diagram.)
4.
On the underside of the Front Table (2) are two threaded mounting holes. Position
the Front Table so that its two threaded holes align with the holes located on the
Top Plate (1A) at its edge. (See Assy. Diagram.)
5.
Secure the Front Table (2) to the Top Plate (1A) by inserting upward two Machine
Screws (69), with two Lock Washers (70), into the two threaded mounting holes
in the Front Table. NOTe: Make sure to securely wrench tighten the Machine
Screws. (See Assy. Diagram.)
6.
On the underside of the Rear Table (3) is one threaded mounting hole. Position
the Rear Table so that the threaded mounting hole aligns with the hole located in
the Top Plate (1A) at its edge. Secure the Rear Table to the Top Plate by inserting
upward one Machine Screw (69), with one Lock Washer (70), into the threaded
mounting hole in the Rear Table. NOTe: Make sure to securely wrench tighten
the Machine Screw. (See Assy. Diagram.)
1.
Place the V-Belt (12) on the Motor's (33A) V-Belt Pulley (32A). Then slide the Motor
upward and pull the V-Belt (12) up and over the Cutter Head's (8) Pulley (11).
(See Assy. Diagram.)
for technical questions, please call 1-800-444-3353.
SKU 32966
TO INSTAll THe V-BelT
Page 10
Advertisement
Table of Contents
