Sierra Wireless AirLink LS300 User Manual page 29

Rev 4 Sep.13
In ACEmanager, mouse over a red AT to the left of a listing to see a popup
showing the AT command for that item. Signal Strength is shown below.
Figure 3-2: Mouse over for AT command
• Most AT commands are prefaced with AT. Exceptions are noted in the ALEOS
Configuration User Guide.
• The acceptable format and parameters are listed with each command in the
ALEOS Configuration User Guide.
• If you enter a recognized AT command, the device responds with "OK." If the
command is wrong, the device responds with "ERROR" or "Unsupported."
Configuring the AirLink LS300
29