Panduit N2RCFR Installation Instructions

© Panduit Corp. 2016
FALLING EQUIPMENT HAZARD
Remove all equipment installed onto equipment rails before performing any adjustments to equipment rail spacing.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY, DEATH, OR DAMAGE TO YOUR EQUIPMENT.

Front Equipment Rail Installation

• Remove existing front rails from cabinet posts (use T25 Torx bit to remove existing screws)
• Install [2] Front Equipment Rails to Front Cabinet Posts with [5] Countersunk Torx screws per rail (use T25 Torx bit)
• Use supplied shims (as necessary) to ensure proper EIA spacing of front equipment rails
REMOVE EXISITING
FRONT EQUIPMENT RAILS
(use T25 Torx bit)
Shim
(**use as necessary**)
INSTALLATION INSTRUCTIONS
Countersunk Torx Screw
(use T25 Torx bit)
[5] screws per rail
For Technical Support: www.panduit.com/resources/install_maintain.asp
N -A N-Type Switch Cabinets
ET CCESS
(N2RCFR, N5RCFR, N8RCFR, N1RCFR Set of Four Cage Nut Equipment Rails)
(N2RTFR, N5RTFR, N8RTFR, N1RTFR Set of Four Tapped Equipment Rails)
WARNING
Page 1 of 3
Part numbers:
V00029CX