Siemens SIMATIC S7-1500 Operating Instructions Manual page 63

Commands to control the CPU
The following table provides an overview of the command line commands supported by the
CPU:
Command
--PowerOnCPU
--PowerOffCPU
--Run
--Stop
--GetStatus
--MemoryReset
--FactoryReset
--IP:
Note
Changing the operating state of a CPU
The user group "software_controller_operators" in the computer administration allows you to
change the operating state of a CPU. The user with whose user rights the command is
executed must be part of this user group.
This user group is not available by default; it needs to be created.
The command can also be executed when a protection level is configured for the CPU.
Parameters of the CPU Control tool
The following table provides an overview of the CPU Control tool parameters:
Parameter
--Force
--Help
CPU 1505SP (F) Ready4Linux Version 2.7
Operating Instructions, 05/2019, A5E46864285-AA
6.1 Operating the CPU via command-line commands
Explanation
Starts the CPU in "STOP" mode.
Shut down the CPU.
Run this command before shutting down Linux. Refer to the section "CPU
behavior when shutting down the operating system (Page 75)".
Sets the CPU to "RUN" operating mode.
Sets the CPU to "STOP" operating mode.
Shows the operating state of the CPU.
Resets the CPU memory.
Resets the CPU to the factory setting.
Identifies and stores the IP address of the runtime communication interface.
Execute this command if the IP address already assigned has changed due
to a download via STEP 7.
Explanation
Skips the warning and sets the CPU to the "STOP" operating mode.
Displays the infotext in the command line editor.
Operation of the CPU
63