Presto Conti Compact Series Operating And Maintenance Instructions Manual page 14

PRESTO
GmbH & Co. KG
Bad Laer
varies PRESTO will supply the corresponding
funnel.
When using a lifting/tipping device to empty
the containers according to the dimensions
shown in the appendix, care has to be taken
that no person stays in the swivel area of the
device. Loading from other containers is
regarded as improper use. Using externally
manufactured loading or suction devices is
subject to the agreement of PRESTO.
The user must be aware of the
power supply of the channel-
type baling press as well as
their interrupting possibilities.
Beyond this the user has to be
familiar with the instructions
according to BGV A2.
According to the chapter "Operation" of the
operating instructions the dangerous zones
have to be paid attention to.
Attention!
To avoid malfunctions it is indispensable to
have the maintenance and inspection work
performed at regular intervals. Changes in
comparison with the normal operation
(increased power consumption,
temperatures or vibrations, extraordinary
noise or odours, response of control
instruments, etc.) show that the function is
impaired.
To avoid malfunctions that may either
directly or indirectly result in serious
personnel or property damages, the
responsible maintenance personnel have to
be informed immediately..
Before taking the unit into operation all
protective devices have to be in protective
position and the locking devices and other
protective measures involved in the control
of the machine have to be in function. The
function of the operating elements has to be
checked.
The channel-type baling press must not be
used if the mains lead is not satisfactory.
Using electrical coupling devices and
adapters for the operation of the channel-
type baling press is not allowed. Only
plugging devices according to VDE 0113 acc.
to DIN EN 60204 may be used.
The mains plug may be replaced by a
qualified electrician only. In case of a
replacement of the mains lead or equipment
connecting line it is not allowed to deviate
from the type stated by the manufacturer.
The mains plug may not be plugged before
the channel-type baling press has been
properly installed at the location.
04/2012 3 - 7