Table of Contents
Advertisement
S
S
UPER
ERVER 6018R-MD/MDR User's Manual
I
C Bus to PCI-Express Slots
2
Use jumpers JI
the System Management Bus (I
the PCI-Express slots to improve PCI
performance. These two jumpers should
be set at the same time. See the table on
the right for jumper settings.
LAN 1/2 Enable/Disable
JPL1 enables or disables the Gb LAN
ports. See the table on the right for
jumper settings.
BMC Enable/Disable
Jumper JPB1 allows you to enable the
embedded Aspeed AST2400 Base-
board Management Controller (BMC) to
provide IPMI 2.0/KVM support on the
serverboard. See the table on the right
for jumper settings.
Watch Dog Enable
Watch Dog is a system monitor that can
reboot the system when a software ap-
plication hangs. Close pins 1-2 to reset
the system if an application hangs. Close
pins 2-3 to generate a non-maskable
interrupt signal for the application that
hangs. See the table on the right for
jumper settings. Watch Dog must also be
enabled in the BIOS.
Manufacturer Mode Select
Close pins 2 and 3 of JPME2 to bypass
SPI flash security and force the system to
operate in the manufacturer mode, which
will allow the user to flash the system
firmware from a host server for system
setting modifications.
C1 and JI
C2 to connect
2
2
C) to
2
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Setting Definition
Pins 1-2
Pins 2-3
BMC IPMI Enable/Disable
Jumper Settings
Pins 1-2
Pins 2-3
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Setting
Pins 1-2
Pins 2-3
5-20
I
C for PCI-E slots
2
Jumper Settings
Definition
Enabled
Disabled
LAN 1/2 Enable
Jumper Settings
Enabled)
Disabled
Jumper Settings
Definition
Enabled
Disabled
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
Disabled
ME Mode Select
Jumper Settings
Definition
Normal (Default)
Manufacture Mode
Advertisement
Table of Contents
