Horizon Fitness PF-P3100 Manual page 20

Towards the
feed roller.
Folded Edges
2
1
Sheet Guides
1
2
Sheet Guides
20 mm (0.79")
Support Roller
Feed Roller Feed Roller Feed Roller
Sh e e t s Sh e e t s Sh e e t s
Load the sheets on the feed table.
- Follow the procedure listed in "Let's Start Folding" on
page 3 and load the sheets on the feed table.
- Load the sheets so that the folded edges are close to
the center of feed table so the sheets feed smoothly.
In the figure to the left, the folded edges are placed
facing the operator side of the machine.
- Do not stack the sheets more than half of the height of
the feed guide. If too many folded sheets are loaded
onto the feed table at once, the sheets may not be fed
23056
straight.
30201E1
Set the feed guides.
If the width of the folded sheets is less than
185 mm (7.2"):
1. Set the front side feed guide (1) as far back as
possible.
2. Push the stack of sheets against the front side feed
guide (1).
Less than
3. Set the rear side feed guide (2) so that it just
185 mm (7.2")
touches the stack.
23056
30201F1
If the width of the folded sheets is 185 mm
(7.2") or more:
1. Set the rear side feed guide (1) as far back as
possible.
2. Load the sheets against the rear side feed guide (1).
3. Set the front side feed guide (2) so that it just
touches the stack.
185 mm (0.20")
or more
23056
30201G1
20 mm (0.79")
Set the support rollers.
- Set the support rollers about 20 mm (0.78") inside both
edges of the stack.
- Space the other support rollers evenly.
23056
Cross Fold/12-Page Letter Fold
15