Setting Offset Value ∆Y - Sony LH61 Instruction Manual

5-1-5. Setting offset value ∆Y
• After completing 5-1-4, press the Axis selector key for the offset value ∆Y setting mode.
• Number keys and
• If the display unit has been replaced and thus the offset value ∆Y has been measured, ∆Y may
• The offset value ∆Y is factory set to 0.0000mm.
Example : Input to the first axis
Operating Procedure
Example:To set the offset value ∆Y to 10 mm.
X
0
1
P
• When ∆Y is not yet measured, refer to "5-12. Offset Zero Point." (See page 42.)
• Numbers that can be input vary according to the resolution.
• The arrow indicator lights and REF flashes during number input, and when the
key are used to set and change the offset value ∆Y.
P
be set in this procedure.
Select the X-axis.
Press the number keys.
Press the Preset key to complete the setting.
Note
Example: In the case of 0.0005 mm: –999.9995 to +999.9995
In the case of 0.01 mm:
If the resolution is made finer after a large value is input with a coarse resolution, an overflow
alarm display will result for the offset value ∆Y.
pressed to confirm the number the arrow indicator goes out and REF lights.
Lights up
–99999.99 to +99999.99
Display
REF
mm
Lights up
REF
mm
Flashes
REF
mm
Lights up
key is
P
17