Sony LH61 Instruction Manual page 46

Inside and outside measurements of workpiece
Inside measurement
Outside measurement
Example: L =100
1

X

X
SET
L
C A
START
X
B C
X
38
L =s +10mm
1 1
L =s –10mm
2 2
C A
Note
Make following measurements in millimeter operation.
Press the in/mm selector key if necessary.
Operating Procedure
Select the X-axis.
Note
If an axis is not selected, all axes are
switched simultaneously.
Set the incremental mode (INC).
(The spot position is displayed.)
The INC indicater lights.
Select the X-axis again.
Press the LOAD key. It is ready for setting the
datum point on the side A (side C).
The arrow indicater flashes.
Touch the side A (side C) with the feeler. On
contact the buzzer beeps and counting starts.
The arrow indicater goes out.
Before touching the side B (side D), select the
X-axis and press the HOLD key.
It is ready for finding L
The arrow indicater flashes.
H
Touch the side B (side D) of the workpiece
with the feeler.
The buzzer beeps and the displayed value is
held, which is the value L
The arrow indicater lights.
Select X-axis again and press the cancel key.
The hold is canceled and the display will show
the present value.
The arrow indicater goes out.
B D
s
1
Direction of movementand polarity
L
1
L
2
s
The display below shows the inside measurement.
2


Flashes
Buzzer
Buzzer
(L ).
1 2 Flashes
(L ).
1 2
'direction
Display
ABS
mm
INC
mm
INC
mm
INC
mm
Counting starts
INC
mm
INC
mm