Specifications; Maintenance - Sony LH61 Instruction Manual

Display unit
Table of Contents

Advertisement

Available languages

Available languages

• There are two ways to use theTouch Sensor: one is for establishing the datum point and the
• Depending on usage, set the display mode to INC or ABS with display mode switching controls
• In the following examples , the resolution is 0.0005mm, and the feeler ball of the touch sensor is
• If a load or hold operation has been erroneously performed, press the relevant Axis selector key
• Be sure to touch the machine table with the touch sensor feeler ball gently. If the feeler ball

5-10-2. Specifications

Model
TS-103A
ø10 × 45 mm or
Shank dia. and length
0.3937 in dia. × 1.772 in
Detection direction
Steel ball, ø 10 mm or
Feeler
0.3937 in dia.
0.002 mm or 0.0001 in
Accuracy
110 mm or 4.331 in
Overall length
3m or
Cable length
10 ft
The cable and the Touch Sensor itself are connected/disconnected through the connector.
Remarks

5-10-3. Maintenance

If the sensor is left unused for a long period, be sure to apply a rust-preventive. Especially, if the
steel ball or shank rusts, the accuracy will be affected.
Rust Veto Heavy by E. F. Houghton & Co. is recommended as a rust preventive oil.
other is for measuring a workpiece without destroying the datum point.
Absolute mode (ABS)
This is a mode for establishing a datum point. A datum point can be established or a distance
from the datum point can be measured by the LOAD/HOLD operation.
Incremental mode (INC)
In this mode, a datum point can not be established.
Pitch measurement of a workpiece can be performed by the LOAD/HOLD operation without
destroying the datum point which has been already established.
before starting the actual controls.
10mm across.
and the
key to cancel the operation, and perform the load or hold operation again.
touches the table roughly, the feeler ball and the table may be damaged.
TS-203A
TS-105A
TS-110A
ø12.7 × 45 mm or
0.5 in dia. × 1.772 in
Steel ball, ø12.7 mm or
0.5 in dia.
0.002 mm or 0.0001 in
110 mm or 4.331 in
5m or
10m or
16.7 ft
33.3 ft
TS-205A
TS-210A
± X, ± Y
3m or
5m or
10m or
10 ft
16.7 ft
3.3 ft
TS-303A
TS-305A
TS-310A
ø32 × 55 mm or
1.260 in dia. × 2.165 in
Steel ball, ø10 mm or
0.3937 in dia.
0.002 mm or 0.0001 in
120 mm or 4.724 in
3m or
5m or
10m or
10 ft
16.7 ft
33.3 ft
35

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents