Handling Instructions - Sony LH61 Instruction Manual

1-2. Handling Instructions

• Do not route the head connecting cable, power cord, etc, together with the machine power line
in one duct.
• Supply power from an AC lamp source.
• Connect the ground terminal to the machine with the supplied ground wire. Make sure the
machine is grounded.
Remove paint or rust completely before
connecting the ground wire.
• Place the display unit more than 0.5 m (20") away from a high voltage source, large current
source, large power relay, etc.
• For installation of the display unit, avoid a location exposed to chips, cutting oil, or machine oil.
If unavoidable, take adequate countermeasures.
• Do not put a vinyl cover directly over the display unit or put it in a closed container.
• The ambient temperature should be in the range of 0 to 40°C (32 to 104°F). Avoid exposure to
direct sunlight, hot air currents, or heated air.
Switchboard
(Locate more than 0.5 m/20" away.)
Welder
• If the power supply voltage is lower than specified, the display may not be illuminated even with
the power switch turned on.
Be sure to use the power in the specified range.
• Note that if the power is interrupted momentarily or the voltage drops temporarily below the
normal operating range, an alarm may operate or a malfunction may occur.
• Be sure to use the display unit inside.
Ground wire
Machine oil
Cutting oil
RESET
X ABS
mm
X
RESET
Y ABS
Y
mm
RESET
Z
Z
ABS
mm
ON
POWER
OFF
REMOTE
SIGNAL IN 1
RESET
R
Sony Precision Technology Inc.
MADE IN JAPAN
SIGNAL IN 2 RS232C
AC IN
SIGNAL IN 3
〜100V-230V
35VA
!
Do not route these together with the
machine power line in one duct.
Chips
BH PRG REF
SET START
F
S
L H
PRINT
7 8 9 P
C L
4 5 6
1 2 3
0
inch mm
LH61
TOUCH
SENSOR
3