Trouble Shooting - Tiger M105X/S Mounting And Operating Instructions

WEEKLY OR EVERY 50 HOURS
ITEM
In Tank Hyd. Fluid
Filter
(10 micron filter)
In-Line High Pressure
Filter
(10 micron filter)
MONTHLY OR EVERY 150 HOURS
Hydraulic Fluid Level
Hyd. Tank Breather
Rear Tire Type
480/80R38
18.4-34
18.4-38
YEARLY OR EVERY 500 HOURS
Spindle Grease
Motor to Spindle Spline
Hyd. Tank Fluid
In Tank Hyd. Fluid Filter
(10 micron filter)
In-Line HP Filter
(10 micron filter)
Hyd. Tank Breather

TROUBLE SHOOTING

SYMPTOMS
Vibration
Mower will not lift
MAINTENANCE
SERVICE
Change
Change
Check
Clean / Check / Replace
Max P.S.I.
29
26
26
Change
Change
Change
Change
Change
Change
CAUSE
1. Loose bolts
2. Cutter assembly
1. Hyd. Fluid low
2. Leaks in line
3. Faulty relief valve
4. Kinked or blocked
5. Faulty cylinder
Maintenance Section 4-4
COMMENTS
Change after first 50
hours only, then every
500 hours or yearly
Change after first 50
hours only, then every
500 hours or yearly
Add as needed
Clean or replace
Element as required
or Change when indicated
by restriction indicator.
REMEDY
1. Check all bolts and tighten
to torque specs. in this section
2a. Check for damaged blades,
disc. Unbalanced or cutter
shaft. Replace if needed.
2b. Check for wire, rope, etc.
entangled in cutter assembly
1. Check and refill Hyd. Fluid.
2. Tighten or replace fittings
and hoses
3. Check pressure in line. Line
pressure in Control Valves
should be at least 2500 P.S.I.
4. Clean or replace lines
5. Inspect, repair or replace
cylinder