Tiger M105X/S Mounting And Operating Instructions page 35

2 1/8" HOLE
CABLE SWITCH BOX WIRING
Refer to the parts section for wiring diagram to hook up the switch box. Cover the
four wires from the switch box with plastic wire wrap provided. Route the wires, that
tap into the tractors power, from the switch box to the front council panel. Remove the
console panel under the steering wheel to access wires. Locate the black wire with
the white stripe. Using a test light or meter verify this wire is the neutral safety wire.
Cut the black wire with the white stripe and connect the green wires from the switch
box as shown in the wiring diagram. The red wire is to be hooked to the tractor ignition
switch or an available slot in the fuse box. NOTE: Be certain that the power taken
for the switch box is "HOT" ONLY when the tractor ignition is "ON".
double check that the line is fused.
Cut a 2-1/8" hole through the floor mat and cab floor at the base of the right console
and the cable mounting bracket. Check under the cab and under the mat for a clean
cut. Run the switch box wires out with the cables and wrap with hose wrap. Secure
the hose wrap with zip ties. Place trim lock around the hole. Run the cables to the
valve. Run the white wire to the solenoid valve. Cover wires with wire wrap.
The wires from the switch box are longer than needed and should carefully cut and
spliced as required. Zip ties should be used to secure the wires and cables to the
tractor framework.
ASSEMBLY
FRONT STEERING CONSOLE - CUT HOLE TO ACCESS
POWER SOURCE FOR SWITCH BOX
Assembly Section 2-7
Also