Tiger JD 5065 / 5085 - 5105M Mounting And Operating Instructions page 54

STOP BOLT ADJUSTMENT
Extend the outboard cylinder all the way out. Adjust the stop adjustment bolt (located
on the top of the draft beam) out until it is up against the bonnet. Lock the bolt down with
the ¾" hex nut.
NOTE: When the outboard cylinder is fully extended, the bonnet or deck should
either be up against the stop or if travel locks are installed, it should be up against the
travel lock. It may be necessary to use either external or internal slugs on the cylinder to
get the correct stroke. If the cutter head is against the stop and the cylinder has stoke
remaining, serious damage will occur.
Proceed to final preparation for operation instructions on the next page.
0003)
ASSEMBLY
Assembly Section 2-24
(ASM-SIDE MNTS-