Tiger JD 5065 / 5085 - 5105M Mounting And Operating Instructions page 112

MAINTENANCE
GREASING THE UPPER AND LOWER SHEAVES
Locate the grease zerks on the ends of the upper
and lower sheave pins as shown below. Inject
Lithium-Complex Extreme Pressure grease
conforming to NLGI2-ISO 320 specifications into
each pin until it protrudes from the ends. These
should also be greased daily or for every 8 hours of
service.
TIGHTENING BLADE BOLTS AND DISK BOLTS
After every 8 hours of operation or daily, the knife
bolts and disk bolts should be tightened as follows:
Knife Mounting Bolts (3 ea.) torque to 800 oiled ft.
lbs.
Disk Mounting Bolts (6 ea.) torque to 204 dry or 180
oiled ft./lbs.
SIDE ROTARY Maintenance Section 4-14
© 2011 Alamo Group Inc.