Tiger JD 5065 / 5085 - 5105M Mounting And Operating Instructions page 115

MAINTENANCE
BALL VALVES
The ball valves at the hydraulic reservoir may need
to be closed during certain maintenance or repair
procedures. THE BALL VALVES MUST BE OPEN
(handle parallel with valve) WHEN TRACTOR IS
RE-STARTED OR WHEN THE PUMP IS
COUPLED TO MOTOR OR P.T.O.! Failure to do so
will result in component failure!
GREASING SPINDLE
Locate grease fitting on inside of deck housing.
Inject Tiger Spindle Lubricant, part number
06540000 into spindle housing. Fill with lubricant
until lubricant weeps out of top spindle seal.
Lubricate spindle weekly or every 40 hours of use.
TIGHTENING SPINDLE BOLTS
The spindle mounting bolts should be checked and
retorqued daily or every 10 hours of service. Torque
the (6) bolts shown below to 357 dry or 315 oiled
ft. lbs.
SIDE ROTARY Maintenance Section 4-17
© 2011 Alamo Group Inc.