Step 8: Door Installation - Thermador Professional Series Installation Instructions Manual

Step 8: Door Installation
CAUTION
The door is heavy and requires two people to
handle it properly.
1. Insert the door hinge into the hinge pocket in the
front frame. When the door is properly installed,
the bottom edge will be parallel to the front of the
range and the hinge will click into position and
support the weight of the door.
2. Tip the door parallel to the floor to free the hinge
locking pin.
3. Carefully remove the pins. The door is nowfree to
close. Install the hold down bracket. Do not tighten
screw. Retain pins for future door removal.
4. Adjust the door height so the latch lock lever and
spacer gauge enters the slot in the door liner as
the door is closing and the top of the door should
be parallel to the bottom of the control panel.
Tighten down screw on hold down bracket.
5. Oven door hinges seated and hold down bracket
is located in proper locked position. Now the door
opens and closes properly.
6. The toe kick panel should be mounted last to
)revent damage by the door.
Photo B. Insert the door hinge into the hinge
pocket in the front frame.
Photo D
of Door
Height adjusting screw
Fig. 15
Photo C Hinge Locking Pin
Hold down
pHinge Locking Pin
(Retain for future
door remowll
Door height
o
O
Fig. 16
18