Thermador Professional Series Installation Instructions Manual page 9

Step 2: Cabinet Preparation
GAS AND ELECTRIC SUPPLY ZONES:
FiG. 3A Gas & E{ectrica{ Supp{y Zone for [)ua_ Fue{ Ranges
Typical placement shown.
Other placement of Gas
Supply and Electrical
Receptacle within the
Electrical and Gas Supply
Zone is acceptable.
NOTE:
A Manual Gas
ShutzOffVaive
(notshown)
must be easily
accessible
through an
adjacent cabinet
without moving
the range.
Gas
3/4" Flex Line to
Appliance
1/2"
240 VAC Receptacle
(Shown) or Junction
1 Centerline of
Electrical
I Zone
2" Maximum Protru-
sion from Walt for
Gas Suppty
/
Floor
Model A B C D E
PD30 8" 12" 10" 6-1/2" 5ol/4"
PD36 10ol/2" 15" 10ol/2" 6ol/2" 5-1/4"
PD48 16ol/2" 16" 15ol/2" 6ol/2" 5-1/4"
The Dual Fuel ranges may be con-
nected to the power supply with a
range supply cord kit or by hard-
wiring to the power supply. It is the
responsibility of the installer to pro-
vide the proper wiring components
(cord or conduit and wires) and com-
plete the electrical connection as dic-
tated by local codes and ordinances,
and/or the National Electric Code.
The units must be properly grounded.
Refer to Step 6 for details.
The range must be connected only
to the type of gas for which it is
certified. If the range is to be con-
nected to propane gas, ensure that the
propane gas supply tank is equipped
with its own high pressure regulator in
addition to the pressure regulator sup-
plied with the range. (See STEP 5.)
NOTE: Anyopening in the wall behind the appliance and
any opening in the floor under the appliance must be
sealed.