Table of Contents
Advertisement
VERSA-4K
SUBNET
GATEWAY
BAUD
USB 2.0 (Receiver Only)
Status Name
MAC ADD
USB RX IP (Sender Only)
USB TX IP (Receiver Only)
LINK SPEED
IR Remote Controller
IR Remote controller can be used to change the
Group ID
of Sender/Receiver. The numeric key pad
on the remote controller can be used to key-In 4 digit
Group ID (0000 to 9999). To use IR Remote
Controller, connect IR Detector Cable, which is
labeled as "Control" to "IR-CTRL" port of VERSA. See
IR Detectors and Emitters
IR Detectors and Emitters
IR Detector cable for Passthrough.
Connected to "IR-IN" port of VERSA.
10
© Copyright 2019 Hall Research, Inc.
Subnet Mask
Gateway
RS-232 Baud Rate
Used to the Connect/Disconnect with Sender in the
same group
Mac Address of the Device
Shows the IP address of the Receiver to which USB is
connected
Shows the IP address of the Sender to which USB
devices are exported
Ethernet Link Speed (Shows 1000M when connected to
1G network)
Shows "No Link!" when Physical Link is down or IP
address is not assigned
for more information.
Description
Fig 5: IR Remote Controller
Advertisement
Table of Contents
