All-in-one console extender dual video, amplified or line-level audio, rs-232, and 3 separate usb extensions: two direct plus one with 4-port hub to 150 meters (500 ft) (20 pages)
Usb 2.0 over utp extender with 2-port hub (8 pages)
Summary of Contents for Hall Research Technologies UHBX-S-WP
Page 1
Model numbers covered in this User’s Manual: Individual Transmitters UHBX-S-WP HDMI on Cat6 (HDBaseT) Wall Plate Transmitter UHCOM-WP RS232+IR Add-on Wall Plate for UHBX-S-WP Kits UHBX-WP-P2 HDMI on Cat6 (HDBaseT) Wall Plate Transmitter and PSE Receiver UHBX-WPC-P2 HDMI+RS232+IR Wall Plate Transmitter and PSE Receiver...
UHBX Wall Plates 1.0 Introduction This manual covers Hall Research's wall plate components of UHBX series of HDMI extenders. The wall plate transmitters can be purchased just by themselves or as a kit that includes a compatible receiver. The basic HDMI sender fits in a single gang Decora®...
UHBX-WPC-P2 HDMI+RS232+IR Wall Plate Transmitter and PSE Receiver Accessories 511-POH-17W PoH Compliant Power Inserter with universal AC input 4.0 UHBX-S-WP Wall plate Transmitter The UHBX-S-WP is an HDMI on Cat6 (HDBaseT) single gang wall plate Transmitter. The package includes the following: UHBX-S-WP Decora® metal insert •...
UHBX Wall Plates The wall plate can also be used with the lower cost UH-1BTX-R (max distance 100 meters) or the economical UH-1BT-R (max distance 70 meters), however since these do not provide power, a compatible PoH inserter is required (Hall Research part number 511-POH-17W). 4.2 Connection Block Diagrams Following are typical ways to configure the extension system.
5.1 Connecting to UHBX-S-WP As mentioned above the UHCOM-WP includes a short cable for connection to the UHBX-S-WP Sender . On the rear of both wall plates there is a small connector. Plug the supplied cable to both connectors. The plug and receptacles are keyed so there is only one way to plug them in.
IEEE 802.3af and will only apply power to the cable if a compliant device is connected. For example you can use the power injector to power the UHBX-S-WP wall plate transmitter if the receiver does not supply power via the UTP cable.
Reach mode or details on IR and RS-232 extension. 7.1 Mounting the Transmitter and Heat Dissipation The UHBX-S-WP comes with a single gang mud-ring. When used in conjunction with the UHCOM-WP add-on, a two gang mud-ring is supplied. It is recommended to use the mud rings for installation. The mud ring has no back so the unit’s rear is not sealed and allows for better heat dissipation.
UHBX Wall Plates 8.0 Troubleshooting If you are experiencing problems getting the extender to work properly, please use the following troubleshooting suggestions. Make sure that all of the connections on both the sender and the receiver are solid. Loose connections are often the cause of issues. ...
HDMI Extension on UTP 9.0 Specifications Video Standards DVI (single link) and HDMI (compliant with HDMI 1.4 video specifications including 12 bit color depth, 3D video and 4K support) Signal type TMDS Connectors Locking HDMI input, RJ45 HDBaseT output Resolutions DVI signal VGA (640x480) thru WUXGA (1920x1200) HDTV signal...