All-in-one console extender dual video, amplified or line-level audio, rs-232, and 3 separate usb extensions: two direct plus one with 4-port hub to 150 meters (500 ft) (20 pages)
Usb 2.0 over utp extender with 2-port hub (8 pages)
Summary of Contents for Hall Research Technologies UH18 Series
Page 1
User’s Manual UH18 4K Video and USB HDBaseT 2.0 Extender Extends 18G HDMI (4K @60Hz 4:4:4) and USB 2.0 to 100 meters Also extends RS-232 and IR Can be powered from either side Part Number Function UH18-S Video and USB HDBasetT 2.0 Sender UH18-R Video and USB HDBasetT 2.0 Receiver UMA1285 Rev NC...
4K Video and USB Extender 1.0 Introduction The UH18 extends HDMI Video and USB 2.0 on a single CAT6 cable to 100 meters or more. The extender kit consists of a Sender (UH18-S) and Receiver (UH18-R). Power, USB, RS-232 and IR (remote) extend on the same cable.
UH18 Typical Connection Diagram 1.1 Features Extends 4K @ 60 Hz up to 100m and 1080p @ 60 Hz up to 150m HDMI 2.0, HDCP 2.2 compliant and supports HDR10 HDMI loop-output on the Sender Audio Extraction on the Receiver (Analog and SPDIF) ...
4K Video and USB Extender 2.0 Package Contents UH18-S (x1) Model UH18-S Sender (x2) Side Brackets with screws for surface mounting (x1) 3-pin terminal strip for RS-232 (x1) IR Emitter cable (can be used on Sender or Receiver) ...
UH18 3.0 Setup 3.1 Installation Connect the HDMI Input on the UH18-S (Sender) to your HDMI Source using a High quality HDMI cable such as Hall Research CHD-SF* SnugFit™ High Speed Latching HDMI cable (HDMI cables are not included). ...
Page 7
4K Video and USB Extender Use the supplied 24 VDC Power Supply to power the Extender. Only one power supply needed and may connect to either the Sender or Receiver depending on your requirements. By default, the power supply is only included with the Sender (UH18-S).
UH18 4.0 Connector and Indicator Functions 4.1 UH18-S (front and back) IR In Connects to the IR Detector Cable IR Out Connects to the IR Emitter Cable USB Hub Connects to any USB 2.0 local devices USB 2.0 Connects to computer with USB 2.0 Type A to B Cable Long Reach OFF (default) –...
4K Video and USB Extender 4.2 UH18-R (front and back) IR In Connects to the IR Detector Cable IR Out Connects to the IR Emitter Cable USB Hub Connects to any USB 2.0 remote devices Long Reach OFF (default) – Extend video to 100m including 4K ON –Extend video to 150m up to 1080p Mute Audio OFF (default) –HDMI Output audio is not muted...
UH18 5.0 Functions 5.1 EDID Management The UH18-S Sender can pass either the Local or Remote EDID to the video source. To pass the remote EDID of the display connected to the HDMI Output of the Receiver, turn the Local EDID DIP switch on the front panel OFF. This is the default mode.
4K Video and USB Extender 5.3 IR Extension The bi-directional IR extension is pass-through. Connect the IR Detector and Emitter cables to the Sender and Receiver to extend IR in both directions. Only one IR Detector cable and one IR emitter cable are provided in the extender kit.
UH18 5.4 RS-232 Extension The RS-232 Extension in UH18 is pass-through and works up to 115K baud. The baud rate settings of the serial device connected at the Sender must match with the serial device connected at the Receiver end for successful full- duplex communication.
4K Video and USB Extender 7.0 Specifications Video Standards HDMI 2.0, HDCP 1.4/2.2 Resolutions DTV/HDTV up to 4K @ 60 Hz YUV 4:4:4 Audio HDMI LPCM 2.0/5.1/7.1 channel , DTS-HD, Dolby-HD Audio Extraction Analog (Line Level) and SPDIF Note: Analog output is only active when the HDMI Audio is 2-channel. SPDIF output is always active regardless of audio format of 2.0, 5.1 or 7.1 channels Peripherals...