Installing The Required Package; Applying Initial Configuration Script - NEC Express Server Express5800 Series Installation Manual

Chapter 1 Installing Operating System
2.3.3

Installing the required package

Install the packages required for the ft control software according to the following procedure.
1. Set the ft control software installation CD to the optical disk drive. The package is mounted
automatically after a while.
2. Execute the following command to copy the file.
# /bin/cp -f /run/media/root/FT1102052/ftsys/pkginst.sh /tmp
3. Remove the ft control software installation CD from the optical disk drive, and insert the RHEL7.2
installation media. The package is mounted automatically after a while.
4. Execute the following command to install the package.
# /tmp/pkginst.sh
5. After installation is completed, the following message appears.
The install has completed.
6. Remove the RHEL7.2 installation media from the optical disk drive.
2.3.4

Applying Initial Configuration Script

Initial Configuration Script provides various settings for stable operation of the system. Be sure to apply the
initial configuration script according to the steps below.
See Chapter 1 (4.1 Processing detail of initial configuration script) for details of initial configuration script.
1. Set the ft Server Control Software Install CD to optical disk drive. After a while, the drive will be
automatically mounted.
2. Run the following command to apply initial configuration script.
# /run/media/root/FT1102052/ftsys/nec_setup.sh
3. The following message appears when the configuration is applied. The system needs to be
rebooted, however, proceed to the next step.
Update done.
Finished successfully.
Please reboot your system.
32
The package may not be mounted automatically depending on the environment. Mount it to
Tips
the desired position in this case. If the mounting destination is different, replace it as
required.
If the optical disk drive is not mounted automatically depending on your environment,
Tips
mount it on the desired location manually. If the mount destination differs, substitute it for
the actual destination appropriately.
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
2. Setting up