Power Button Board - HP OMEN 17-cb0000 Maintenance And Service Manual

Power button board

NOTE: The power button board spare part kit does not include the cable. The cable is available as spare part
number L57364-001.
Table 6-9 Power button board description and part number
Description
Power button board
Before removing the power button board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
5. Remove the fan/heat sink (see
Remove the power button board:
1. Remove the two Phillips M2.0 × 3.0 screws (1) that secure the board to the computer.
2. Rotate board upside down so you can access connector underneath (2).
3. Disconnect the cable from the ZIF connector on the board (3).
4. Remove the power button board from the computer (4).
Reverse this procedure to install the power button board.
IMPORTANT:
not show.
48 Chapter 6 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
Solid-state drive and Optane memory module on page
Heat sink/fan assembly on page
When replacing the power button board, be sure to replace the tape so the internal light does
(Preparation for disassembly on page
30).
38).
Spare part number
L57371-001
29).
44).
32).