Display assembly
NOTE:
The display assembly is spared only at the subcomponent level.
Before removing the display assembly, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the fan/heat sink (see
5.
Remove the system board (see
Remove the display assembly:
1.
Remove the wireless antenna cables from the clips that secure them to the computer chassis (1).
2.
Remove the two Phillips M2.5 × 5.0 screws (2) from each hinge.
3.
Open the computer (3), and then separate the display from the computer (4).
4.
If it is necessary to replace display assembly subcomponents, first remove the bezel:
a.
Release the top edge of the display bezel (1) from the display assembly.
IMPORTANT:
b.
Release the left and right edges of the display bezel (2) from the display assembly.
c.
Release the bottom edge of the display bezel (3) from the display assembly.
52
Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page
38).
Heat sink/fan assembly on page
System board on page
Be careful not to bend or break the narrow sections of the bezel when removing.
29).
30).
44).
49).