Heat Sink/Fan Assembly - HP OMEN 17-cb0000 Maintenance And Service Manual

Heat sink/fan assembly

Table 6-7 Heat sink/fan assembly, thermal pad, and thermal grease descriptions and part numbers
Description
Heat sink/fan assembly for use in models with GeForce GTX 1660 graphics
Heat sink/fan assembly for use in models with GeForce GTX 1660Ti graphics
Heat sink/fan assembly for use in models with GeForce GTX 2060 graphics
Heat sink/fan assembly for use in models with GeForce GTX 2070 graphics
Heat sink/fan assembly for use in models with GeForce GTX 2080 graphics
Thermal grease
Thermal pad kit
Before removing the heat sink/fan assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the heat sink/fan assembly:
1. Disconnect the two fan cables from the system board (1).
2. Remove the power connector cable from the routing channel in the left fan (2).
3. Remove the WLAN antenna from the routing channel in the right fan (3).
4. Remove the two Phillips M2.0 × 5.0 screws (1) from each fan.
5. Remove the eight Phillips M2.0 × 3.0 screws (2) in the order indicated on the heat sink.
44 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 38).
29).
30).
Spare part number
L57367-001
L57366-001
L62864-001
L62865-001
L62866-001
L65268-001
L57444-001