Folding Mode (Z-Cut 10); How To Manage A Curling Tape; Use Narrow Tape / Use Two Rolls In A Same Time; Other Functions - Yaesu ZCUT-9 Instruction Manual

INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10

FOLDING MODE (Z-CUT 10)

This mode is to fold the tape edge.
This mode can be used with other function.
Press SELECT BUTTON more than 1 second.
Green LED will be flashing if pressing SELECT BUTTON more than 1 second. If setting is completed and
press START BUTTON, a piece of tape with folding the edge as set the cutting length will be ready to take
after pressing START BUTTON again.
Set other mode as depends on your requirement.
In the case of folding mode, minimum cutting length is 15mm. The folding length is fixed by 7mm.
When cancelling folding mode, please press SELECT BUTTON more than 1 second. Please make sure
that green LED is off.

HOW TO MANAGE A CURLING TAPE

Press the HOLD DOWN ROLLER RELEASE BUTTON in order to open the HOLD DOWN ROLLER UNIT.
Extend the ROLLER LOCK LEVER so that the roller will not turn.
Close the HOLD DOWN ROLLER UNIT.
With the rollers locked, the tension may cause the length to vary. Cut several test pieces in
order to adjust the length if needed..

USE NARROW TAPE / USE TWO ROLLS IN A SAME TIME

If the tape is lesser than 25 mm width or you want to dispense two rolls in a same time,
use the SEPARATOR.
Cut lesser than 10 mm width of tape, put the GUIDE PLATE on the SEPA-RATOR.
Remove the SEPARATOR from the bottom of body.
Open the HOLD DOWN ROLLER UNIT.
Insert the SEPARATOR into the body by slotting in to the bottom of the cavity.
When you cut the tape lesser than 10 mm, put the GUIDE PLATE onto the Separator.
Place one roll of the tape or either side by inserting a SEPARATOR for loading tape.
To hold the tape by adjusting TAPE HOLDERS, it is unnecessary to push the SEPARATOR out
of position.
When dispensing two roll of tapes in a same time, it is a must to feed-in both of its' length in a same time.
Remove the first piece of tape.
When the second piece of the tape is removed, both side of tapes are also dispensed.

OTHER FUNCTIONS

FLEXIBLE TAPE
SUPPORT
When you cut the tape longer
or cut non-adhe-sive
tape / film, use
FL-EXIBLE TAPE SUPPORT
in order to avoid the tape
fall down.
26
ASSIST STAND
Based on the tape
material or workpiece
purpose, use the ASSIST
STAND in order to let
the body of machine
towards a lower level.