Programing Function; Operating Example - Yaesu ZCUT-9 Instruction Manual

PROGRAMING FUNCTION

Function that cuts the material registered from A to F accordingly. As refer to the following figure,
operation will keep working. This function may apply every mode.
Please follow the instruction on page 7.
Set the cutting length from A to F as you prefer.
Please set the cutting length in ZERO for between B to F if not necessary. Then skip the
position registered with ZERO accordingly and operate repeatedly.
Apply the cutting length to your first cutting.
Press AUTO/MANUAL BUTTON more than 1 second.
Then [ . ] will appear on the lower right of Alphabet.
Press AUTO/MANUAL button and select AUTO MODE or MANUAL MODE.
Press START BUTTON and tape is ready to take.
When setting MANUAL MODE, the next cutting length will be displayed.
When setting AUTO MODE, the next cutting tape is ready to take with displaying the cutting
length.
When discontinuing Program Function, please press AUTO/MANUAL BUTTON longer and make
sure that [ . ] is eliminated.

operating example

in the case of 6 different cut length setting
in the case of zero setting for E. F.
Please take the following procedure when using P MODE or L MODE. After setting Programing
Function, press SELECT BUTTON and P will be displayed. Set the number of cutting and press
START BUTTON. Material will be cut until the number reaches ZERO.
After setting P MODE or L MODE, press AUTO/MANUAL BUTTON if you want to have
Programing Function.
INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10
25