P - Mode (Preset Mode); L - Mode (Loop Mode) - Yaesu ZCUT-9 Instruction Manual

INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10

P - MODE (PRESET MODE)

The machine is able to be programmed.
A signal will be shown based on your selected quantity of pieces and it will all cut out.
(Maximum 999 pieces.)
A buzzer will has sound when the program is finished.
You can use the mode either MANUAL or AUTO.
Press SELECT BUTTON to choose your needed length.
Press SELECT BUTTON for three seconds then it will indicates "Lcon".
Press SELECT BUTTON again then it will indicates "P".
Use +/- BUTTON and set your needed number of quantity.
Choose AUTO or MANUAL by USING AUTO/MANUAL BUTTON.
When you press the START BUTTON, the machine will feed-in and cut out a piece of tape for
testing purpose.
To operate the machine by using MANUAL MODE, press the START BUTTON and feed-in a
piece of tape after take it out.
To operate the machine by using AUTO MODE, the machine will feed-in a piece of tape
automatically.
The signal shows numbers backwards when feeding-in another piece of tape.
When the DISPLAY indicates "0", the buzzer will has a sound.
The DISPLAY indicates the number of pieces that is preset. Please wait until the buzzer
stops.
If you take the tape out before the buzzer stops, the LED LAMP will flash so you need to
press the START SWITCH again.
If you try to change the mode (AUTO/MANUAL) when machine is operating, just press AUTO/
MANUAL BUTTON.
If remaining P MODE and switching off, the number of cutting set will be registered.

L - MODE (LOOP MODE)

You can preset the quantity of piece which will be cut out. (Maximum 999 pieces) The machine
will cut out the pieces based on your selected quantities then it will stop.
Press the SELECT BUTTON and decide the length of tape.
Press and hold SELECT BUTTON so that DISPLAY will indicates "Loon".
Set the number of pieces to be cut out by using +/- BUTTON.
If you want to set the number of cutting in every 100pcs, please press AUTO/MANUAL
BUTTON while L con description and increase by 100pcs every time you press. If you want
to set the number of cutting in 1-figure or 2 figure, please press +BUTTON or -BUTTON.
When you press the START BUTTON, DISPLAY indicates a signal shows numbers backwards and
cutting continuously.
When the DISPLAY indicates "0", the buzzer will has sound then the machine is stopped.
To stop the machine while running under L-MODE, press the START BUTTON.
Caution
The number of cutting set will remain registered even if switching off while L MODE.
However, it will be eliminated if pressing SELECT BUTTON longer for setting.
24