Mode Setting - Yaesu ZCUT-10 Instruction Manual

Set the Tape Length
◆Make sure that DISPLAY indicating <cutting length>.
The cutting length is always indicates in some alphabets like A,b,C,d,E,F.
◆Set the cutting length.
Set your needed length by using +/- BUTTON.
The cutting length is adjustable in between 5 mm to 999 mm.
Can set six different length by using SELECT BUTTON.
If you press +/- BUTTON in a short while, the length in changed to 1 mm.
And if you press +/- BUTTON longer, if shows fast foraward.
Caution
The actual length is differ from the displayed length depends on the type
of the tape and its condition.
When cutting short length of tape, the length may not cut consistently
or tape is jammed.
Try several test cuts to insure proper operation.
If pressing －BUTTON for setting from b to F, you will be able to set ZERO.
However, machine will not start while alarming even though pressing
START BUTTON.

Mode Setting

MANUAL MODE
◆Make sure that Blue LED is off.
When the LED LAMP is flashing or turned on, press AUTO/MANUAL
MODE and turn off the LED LAMP.
◆Press the START BUTTON once, the machine will feed-in a piece of tape
then cut it out based on your set length.
◆To cut another piece, press START BUTTON again.
AUTO MODE
◆Make sure that the Blue LED is flashing.
When the LED LAMP's lights are off, press AUTO/MANUAL BUTTON
and let the LED LAMP to flash.
◆Press the START BUTTON once, the machine will feed-in a piece of tape
then cut it out based on your set length.
When that piece of tape is removed, the machine will feed-in another
piece then cut it out.
The machine will feed-in and cut a new piece of tape once the piece of
tape is remomved.
8
INDICATE CUTTING LENGTH
SELECT
A～F
SET THE CUTTING LENGTH
＋
INCREASE NUMBER
－
DECREASE NUMBER
SET AUTO / MANUAL
BLUE LED LAMP
MANUAL MODE
AUTO
MANU
AUTO MODE
MANUAL MODE
LIGHT OFF
TAPE FEED
CUT and STAND BY
START
REMOVE THE TAPE
AUTO MODE
FLASHING
LIGHT ON
TAPE FEED
CUT and STAND BY
START
REMOVE THE TAPE