Load The Tape - Yaesu ZCUT-9 Instruction Manual

INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10

LOAD THE TAPE

Plug in the AC CORD to the AC CORD INLET.
Make sure the POWER SWITCH is off then plug into an appropriate grounded AC outlet.
Turn the POWER SWITCH on.
When the POWER SWITCH is turned on, a buzzer will has a sound.
At this moment, the mode is set to MANUAL.
Press the HOLD DOWN ROLLER RELEASE BUTTON.
Place a roll of tape in the machine.
Hold the tape by adjusting the POWER HOLDERS.
Adjust the TAPE HOLDERS to a proper width, slide the TAPE HOLDER ADJUST LEVER from the
front to the rear of the machine then close it.
The TAPE HOLDERS should hold the roll lightly in the center of the cavity of the machine.
This is very important because it keeps the tape in the center.
This tape passes over the SENSOR in front of the BLADE UNIT.
To support a larger roll of tape, pull the LOWER HOLDER out.
Put the tape on the TAPE FEED ROLLER.
Press the FWD BUTTON until the tape comes out from the TAPE OUTLET.
When using a strong sticky adhesive tape, pull the little bit tape out in positioning into the
TAPE INLET.
Press the FWD BUTTON continuously for a few seconds, also help the tape in positioning in the
TAPE INLET.
After the tape is loaded and the TAPE HOLDERS are adjusted, close the HOLD DOWN ROLLER UNIT.
Press the START BUTTON.
Remove the first piece of tape and discard it.
Now your ZCUT-9GR is ready to use.
!
ALWAYS USE TWEEZERS TO REMOVE TAPE.
!
WHENEVER SET THE TAPE, MAKE SURE THAT ADHESIVE SIDE
OF TAPE IS ALWAYS FACED DOWN.
When you take the roll of tape out from the machine, pull the tape backward and pressing REV
BUTTON.
22