Yaesu ZCUT-9 Instruction Manual page 29

ROLLER UNIT
When tape jammed, you can remove ROLLER UNIT without using any tools and make sure about the status of Roller Unit.
Machine can be stable due to easy cleaning and removal of tape waste.
Please switch off and remove power cord from machine.
Remove BLADE UNIT.
Please take the following procedure.
Pull UPPER CASE of Front Panel forward -2mm.
1
Lift UPPER CASE up while pulling and open it.
2
Remove P.C.B (A) .
3
Push and release HOLD DOWN ROLLER UNIT.
4 - 5
Apparently lift ROLLER UNIT up.
6
When removing FRONT ROLLER, please take the following procedure.
CD Pull the PROJECTION on ROLLER UNIT from side to side.
7
Lift up and open TAPE GUIDE PLATE.
8
Remove FRONT ROLLER.
9
If pulling SENSOR down forward and follow the instruction as mentioned above,
10
FRONT ROLLER can be removable without removing ROLLER UNIT.
When assembling, please take the procedure conversely as you do.
Notice
*When removing Roller Unit, please be careful not to lose any of gears due to dropping.
*When assembling, please assemble the right parts to the right position.
*Please do not put P.C.B. cord between any of parts.
INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10
29