Table of Contents
Advertisement
Superabrasive
3. HANDLING AND TRANSPORTATION
PREPARING THE MACHINE FOR TRANSPORTATION
Unplug the motor cable plug from the
control box and disconnect the water hose
from the main head by pulling it out (Fi g.3.1)
(Fi g.3.2). Wind the electrical cable on the
carriage. Release the pin sets, which attach
the head to the carriage. Pull out the hoses
(Fig.3.3), and dismount the head from the
carriage.
The head of the LAVINA®25LM‐S‐E machine
has one bar and support handles intended for easy moving and transportation.
LIFT THE MACHINE FROM WORKING TO TOOL MOUNTING POSITION
Pus h the front handle down and swivel it to the front ( Fi g.3.4). Pull the handle up and ensure the head is stable in the upright
position, for
Mounting/dismounting the tool. Ensure that the water tank is
empty
before flipping the machine. Pull the head to upright position
(Fig.3.5). The machines manufactured after Jan.1 2014 are
with changed locking of the front handle as shown on the
fig.3.4.1.
LIFTING
Figure 3.6
ADJUSTING THE HANDLE
The Handle on the frame is
adjustable in height and allows
the operator to work in a correct
and safe posture. The machines
manufactured after Jan.1 2014
are with changed locking of the
handle on the frame.The unlocking is by pulling the handle ( fig.3.4.1)The locking is automatically under action of the
spring.Fig.3.7.2 shows all possible position of the handle. Choose the upright position to move easy the machine.
STORAGE
Always store and transport the Lavina®25LM‐S‐E machine in a dry place. Never transport the Lavina®25LM‐S‐E machine unprotected;
it may be damaged if transported unprotected during rain or snow.
When storing the machine, the temperature may
fall to or less than 32F (or 0°C) , therefore, you
should empty the water from the system using the
following steps:
‐ Pull out the hose of the tank (Fig. 3.10)
‐ Using compressed air, blow out the
water from the system for the two
positions of the turn‐cock (Fig. 3.11, Fig.
3.12).
User Manual
Original Language
Figure 3.1
Lifting the machine by crane is possible with the eyebolt that is mounted on the carriage (see Fi
g.3.6). The eyebolt and machine construction is rated only for the weight of the machine. Do not
lift any other loads on the machine. Always use hoisting equipment rated for 300 kg or 660 lbs .
Figure 3.7.1
Figure 3.7
Figure 3.10
Lavina® 25LM‐S‐E
Figure 3.2
Figure 3.4
Figure 3.7.2
Figure 3.11
6
12/2014
Figure 3.3
Figure 3.5
Figure 3.4.1
Figure 3.8
Figure 3.12
Advertisement
Table of Contents
