Table of Contents
Advertisement
Superabrasive
For the two other pulleys, loosen the five bolts of each pulley between the base plate and the motor base disc (Fig.9.7.13). An oil
seal ring (Fig.9.7.14) and a seal (Fig.9.7.15) should be placed on top of the pulley before mounting.
9.8 MOUNTING THE BELT
Figure 9.8.1
9.9 MOTOR CONNECTION
If you replace the motor, please check the cable connection and follow the figures below.
LAVINA® 25LM‐S‐E
The motor is connected in "Star"
380 Volt, reminder for the wire connection of the motor.
Figure 9.9.1
User Manual
Original Language
See here the schematic of the belt on the pulleys (Fig.9.8.1).
To dismount/mount the belt, follow the tensioning instructions in the chapter:
Checking the tension of the belt.
Lavina® 25LM‐S‐E
19
12/2014
Advertisement
Table of Contents
