(Figure 6-7: MBB Bus Bar Installation for Single Source Input & Single
6.3.2. Dual Source Input & Single Phase Output
1. Install the bus bars by following Figure 6-8.
2. Connect to AC source (L1/ L2/ L3/ N): connect L1 to mL1; L2 to mL2; L3 to mL3;
N*
1
to one of the N terminals.
3. Connect to bypass source (L/ N): connect L to bL1, bL2, or bL3 ; N*
the N terminals.
4. Connection to the loads (L/ N): connect the load's L to L1, L2, or L3 and the
load's N to one of the N terminals.
NOTE:
1
*
For dual-source input configurations, the main AC source and the
bypass source must use the same neutral (N).
Amplon RT Series
Phase Output Configuration)
25
1
to two of