Advertisement
Drill 6 x 3mm holes from below into the deck (but not into the inner step) so that they are not visible
from the outside. Glue the compass part (68) into place.
Shown here is the whole assembly. Glue the top edge (66) flush with the upper edge.
Now pre-bend the steps (83) from brass wire according to the plan and drill the holes for them into the
tower. Before gluing them into place, make a strip from 2mm ABS that you can push as a distance
piece between the steps and the tower wall. Do the same for the handrail supports (79) and the
handrails (78). Bend the balcony railing of the tower carefully around a round object of a suitable
diameter and solder it to the supports. Now drill the 1mm holes for the supports into the floor of the
Page 17
© Klaus Krick Modelltechnik Knittlingen August 2002
Advertisement
