Advertisement
File flat for easier drilling.
Drill through the half fins with the ends of the shaft positioned right on the outside.
Glue the half rudders together and let them dry. Check the alignment of the fins by placing them on a
level surface. Carefully sand the glued edges.
The small fins for the display model (44) are glued together from the pre-cut parts. A 3mm hole is
drilled from the side and glued to the rudder shaft (46). First sand the profile form carefully to shape.
The second fin may only be glued after assembly.
Inserting the Rudders
The fore fin of the mobile model is assembled in the following order. Ready assemble one fin, then
stick through one side of the vessel, push on the fin lever (51) with the already hooked-up wire (37),
then stick the shaft through the second side of the vessel and mount the second fin there.
Page 13
© Klaus Krick Modelltechnik Knittlingen August 2002
Advertisement
