Krick 20310 Instructions Manual page 15

Type vii b

Attaching the Ornamental Deck

The ornamental deck is assembled from the 4 deep-drawn thin polystyrene parts. Carefully cut these

out with a pair of scissors and fit the transfer passages carefully to the cutting areas of the cover and

the hull. Carefully cut out the section for the tower (64) so that this tower part fits precisely into the cut-

out of the deck. Then glue together the decks with the hull using "UHU allplast" (IMPORTANT! Do not

use ABS adhesive, as it does not bond the polystyrene.) The laterally visible slots between hull and

decks can be filled with putty or "UHU allplast". When the glue is dry carefully make the cutout in the

lower deck for the flood tank, but this should be little smaller that the tower can sit upon this deck.

Assembly of the Tower

First cut out the upper deflection edge (66) inside from the inner side of the form part. Then cut it from

the outside, as shown.

The upper side panel (65) is cut out from the inside.

Cut out the lower tower part - below from the inside and above from the outside. The illustration shows

it upside down.

In the tower deck (67), first of all file the 8 raised strips flush with the deck. Then cut out the inner

frame (69) from outside starting from the outer side. Drill the compass (68) initially with 3mm, then cut

it out from the outside. The rear of the compass is then cut out from the inside.

Page 15