Advertisement
Then turn the form part around and cut out the tower deck from the inside. Repeat this with the inner
frame (69) and use a small round file to work out the semi circular apertures. Drill 4 x 3mm holes in the
raise for the periscope in the middle of the deck.
Sand the edges until the deck fits cleanly into the lower tower part. Now glue it into the tower and let it
dry. File the edge down to deck level but be careful that you do not file any detail. Cut apertures into
the floor of the lower tower part 4 as shown.
Glue the upper part (65) to the lower part (64) with the deck (67). Then glue in the inner step (69).
Page 16
© Klaus Krick Modelltechnik Knittlingen August 2002
Advertisement
