Safety And Precautions - ASL INTERCOM MPS Series Installation Manual

6 Safety and
Precautions
Observe all safety information both on the product and in
this section.
Environmental
The temperature and humidity ranges shown in the
specifications for this product must not be exceeded.
This equipment must not be installed in an area that is
subject to a corrosive atmosphere, excessive moisture
or may allow water or other liquids to come into contact
with the unit or its external connections. Objects filled
with liquids such as vases should not be placed upon it.
Wall-Mount Bracket Installation
To prevent injury, the wall/desk-mount
!
!
microphone must be securely attached to
the wall/desk in accordance with the
installation instructions.
EMC
The signal to noise ratio of this product may be reduced:
•
in the vicinity of strong magnetic fields, e.g.
transformers or induction loops
•
in the close proximity of some radio frequency
transmitters
If this occurs, re-location of the equipment or the signal
cables is recommended.
Electrical Safety
Ensure power supply cabling is adequately
!
! rated.
Always replace blown fuses with the
correct type and rating.
ESD Precautions
This product contains static-sensitive devices. Observe
ESD precautions when working on the equipment with
the cover removed.
MPS-Series – Installation Guide
Unpacking and Handling
The equipment should be unpacked and inspected
immediately on receipt. If damage has occurred please
advise your carrier or supplier.
!
It is advisable to retain the original equipment packing in
the event that the equipment ever needs returning for
service.
Ensure that the name and address of the Authorised
Distributor from whom you purchased the unit is
recorded on the "Service and Warranty" page of this
manual for future reference.
Packing for Return for Repair
!
!
Advice on packing the product for return can be provided
by ASL.
U-0664-0174.doc – Issue: 07 complete, approved
Page 23 of 24
This equipment contains electronic
!
devices that are sensitive to electrostatic
discharge. Please take precautions to
avoid damage to the electronics by static
electricity.
All electronics assemblies must be
!
properly packed in ESD protective
packing for transport, to prevent physical
and ESD damage.
The filler material used for packing for
!
return for repair must be antistatic or
static dissipative, as this may come into
contact with exposed connectors, wiring,
or PCB assemblies. The use of non-
conductive filler material may cause
damage to the electronic assemblies
reducing their operational life, or even
destroying them.