Natural Gas Installation - Rinnai 4 burner Gourmet Customer's Operating And Assembly Instructions

12
INSTALLATION OF SIDE BURNER
GAS PIPING CONNECTION
(Side burner models only)
1. Attach the short hose to
the dual outlet adaptor
of the side burner
control valve.
Attach the other end
to the main barbecue
manifold inlet and
tighten with a shifter.
Take care not to overtighten.
2. Attach regulator hose to outlet of
dual outlet adaptor. Tighten with
shifter, taking care not to overtighten.
3. Leak test all connections thoroughly with a soapy
water solution prior to lighting the barbecue.
Refer page 16 for lighting instructions for side burner.
USE TOOLS TO SECURE
!
CONNECTIONS. TEST FOR LEAKS
WITH A SOAP SOLUTION (Refer page 4)

NATURAL GAS INSTALLATION

This barbecue is also certified for use on natural gas.
Contact the manufacturer for advice in relation to using
your barbecue on natural gas.
Refer to page 23 or back cover.
If your barbecue is supplied direct from the factory
in a natural gas specification, then it must be installed
by an authorised person.
ENSURING BURNER CONTROLS ARE OFF
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are in
'OFF' position.
NOTE: The 'OFF' position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word 'OFF'.
When the white marking, or the word 'OFF' printed
on the plastic control knob, aligns with the small black
dot / a short vertical black line / or the word 'OFF' then
the burner is in the fully off position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
Familiarise yourself with the general information
and safety guidelines located at the front of this booklet.
Check to see that gas cylinder is filled and that end of
each burner tube is properly located over each valve
orifice. Set burner controls to 'OFF' position.
A S S E M B L Y
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE
TEST FOR LEAKS WITH A
!
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME (Refer page 4)
CONNECTING TO GAS SOURCE
1. Hang filled gas cylinder on
the cylinder hook.
2. Attach cylinder connection
device of regulator and
hose assembly to cylinder
valve outlet.
3. Open the gas cylinder
valve fully to allow gas to
flow.
4. Leak test all connections thoroughly using a soapy
water solution prior to lighting the barbecue.
Refer to Safety Information at beginning of booklet.
5. If a leak is found, turn gas cylinder valve off and do
not use barbecue until repairs or replacement can
be made by a local gas supplier.
DISCONNECTING FROM GAS SOURCE
1. Turn the burner control 'OFF'.
2. Turn the gas cylinder valve off fully.
3. Detach the regulator assembly from gas cylinder
valve.
DISCONNECT AND REMOVE GAS
!
CYLINDER WHEN MANOEUVRING THE
BARBECUE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS.
IF THIS INFORMATION IS NOT
!
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
DO NOT STORE A SPARE GAS
CYLINDER UNDER OR NEAR THIS
APPLIANCE.
NEVER FILL THE CYLINDER BEYOND
80% FULL.
THIS BARBECUE IS ONLY TO BE
USED OUTDOORS.
12