Rinnai 4 burner Gourmet Customer's Operating And Assembly Instructions page 10

10 T R
TROLLEY ASSEMBLY (Cabinet model)
1. Before assembling trolley ensure all components
are available as per listing.
2. Secure right-angled brace to trolley leg using 8 x
12 mm screws.
3. Install the bottom shelf between trolley leg
assemblies. Ensure holes for magnetic door
stopper are facing the front. Secure loosely with
65 mm Phillips-head bolts and nuts provided.
4. Fix magnetic door stopper to base tray using 2 x
15 mm bolts.
5. Carefully position partially assembled trolley
laying down as shown in diagram 2. Fasten the
wheel to the trolley leg as shown in diagram 2 with an
axle bolt. Secure with washer and nut. Clip the
hubcap onto the wheel and repeat steps for second
wheel.
6. Secure the castor to the bottom of the castor-side
trolley leg by turning the threaded castor stem
clockwise until it fully stops. Fasten firmly using a
shifter.
7. Attach the rear panel to the trolley legs using 4 x
19 mm screws as shown in diagram 3. Do not tighten
screws.
8. Tighten all bolts and nuts to bottom shelf brackets/
bottom shelf. The partly assembled trolley is now
ready to connect with the barbecue body.
9. Remove the cooking plates and flametamer from
within the barbecue body, and position the
barbecue on its rear side as shown in diagram 4.
(Diagram shows barbecue without hood for simplicity).
10. Manoeuvre the barbecue body into position and
align the 3 openings in legs with the 3 openings in
the barbecue body side panels. Attach the barbecue
body to the legs through the lower openings using 4
x 65 mm bolts. Finger tighten the nuts. Ensure that
the wheels are on the left side of the barbecue body.
O L L E Y A S S E M
Diagram 1.
Hubcap
Diagram 2.
Secure here
Diagram 4.
B L Y
Right-angled
brace
Wheel-side
trolley leg
Rear panel
mounting
holes
Castor-side
trolley leg
Castor
Rear panel
Diagram 3.
10
Barbecue
body