Gas Installation - Rinnai Impressor 8 Operating And Assembly Instructions Manual

13
ENSURING BURNER CONTROLS ARE OFF
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, make sure all burner controls
are in 'OFF' position.
NOTE: The 'OFF' position on the control panel is
identified by a black vertical line. When the line or the
word 'OFF' printed on the control knob aligns with the
black vertical line on the control panel, the burner is in
the fully 'OFF' position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual. Check to see that gas cylinder is filled and that
the end of each burner tube is properly located over
each valve orifice. Set burner controls to 'OFF' position.
CONNECTING AND DISCONNECTING
TO GAS SOURCE
TEST FOR LEAKS WITH A
!
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME. (Refer page 4)
CONNECTING TO GAS SOURCE
1. Attach hose and regulator assembly to the main
barbecue gas piping.
shifter.
2. Locate the gas cylinder onto the gas cylinder storage
tray on the RHS of the trolley bottom panel.
Refer diagram below.
Gas
cylinder
G A S I N S T A L L A T I O N
Tighten securely with a
3. Attach the cylinder connection device of regulator
and hose assembly to cylinder valve outlet.
4. Open the gas cylinder valve fully to allow gas to
flow.
5. Leak test all accessible connections thoroughly
with a soapy water solution prior to lighting the
barbecue.
Refer to Safety information at beginning of booklet.
6. If a leak is found, turn gas cylinder valve off and do
not use barbecue until repairs or replacement can
be made by a local gas supplier.
DISCONNECTING FROM GAS SOURCE
1. Turn the burner control 'OFF'.
2. Turn the gas cylinder valve off fully.
3. Detach the regulator assembly from gas cylinder
valve.
DISCONNECT OR REMOVE GAS
!
CYLINDER WHEN MANOEUVRING THE
BARBECUE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS
IF THIS INFORMATION IS NOT
!
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
DO NOT STORE A SPARE GAS CYLINDER
IN THE STORAGE COMPARTMENT OR
NEAR THIS APPLIANCE.
NEVER FILL THE CYLINDER BEYOND
80% FULL.
THIS BARBECUE IS ONLY TO BE USED
OUTDOORS.
NATURAL GAS INSTALLATION
This barbecue is also certified for use on natural gas.
Contact the distributor for advice in relation to using
your barbecue on natural gas. Refer back cover.
If your barbecue is supplied direct from the factory
in a natural gas specification, then it must be installed
by an authorised person.
SETTING OF THE 'APPLIANCE TEST POINT
PRESSURE' ON NATURAL GAS
Operate 4 right burners on 'HI'. Attach manometer to an
injector of one of the unlit burners. Adjust regulator
until 1 kPa pressure is achieved with 4 burners operating.
13