Installation Options; Basic Installation Steps - Adaptec ASR-6805Q User Manual

Figure 1
2. Attach the low-profile bracket to the controller board. The low-profile bracket is installed on the
back side of the controller, with the mounting screws inserted from the front of the controller, as
shown the Figure 3.
Insert the screws through the holes on the front of the controller, then fasten the screws to the
bracket with a Phillips screw driver.
Caution: The mount points on the low-profile bracket have a smooth or flat side
and a raised side that looks like a spacer (see Figure 3). Be sure to install the bracket
with the flat side against the controller PCB and the raised side facing away from
the PCB.
Caution: The torque on the mounting screws should be a maximum of 3.0-4.0
lbf-in to avoid deformation. Be sure that the controller is not bent after attaching
the low-profile bracket to the controller board.

Installation Options

When you install your Adaptec RAID controller, you can choose to create a bootable array and then
install your operating system and the controller driver on that array.
Alternatively, you can complete a standard installation, where the controller driver is installed on an
existing operating system.

Basic Installation Steps

This section describes the installation process. Follow the steps for the installation option you've chosen.
Proprietary and Confidential to PMC-Sierra, Inc.
Document No.: CDP-00277-02-A Rev. A, Issue:
Serial Attached SCSI RAID Controllers Installation and User's Guide
Back of board
Front of board
Back of board Raised side of bracket
Figure 3
Remove mounting
screws with Phillips
screw driver
Figure 2
Flat side of bracket
Front of board
34