Dab Radio Operation - Taga Harmony HTR-1000CD Instruction Manual

DAB radio operation

Caution!
• Make sure that you have correctly connected and fully extended the antenna.
• You can program a maximum of 30 DAB radio stations.
Store DAB radio stations automatically
1. Rotate the SOURCE knob on the unit or repeatedly press the
remote control to select DAB source. The word "DAB" will be displayed on the LCD.
2. Press the SCAN button on the remote control to activate automatic program mode.
• [SCANING] is displayed.
• All available stations are programmed.
• The first programmed radio station is broadcast automatically.
Store DAB radio stations manually
1. Tune to a radio station.
2. Press the PROG button on the remote control to activate program mode.
• The preset number will blink.
3. Press the PRESET
radio station.
Note! If you select a number higher than 30, then the preset number will be changed to
"1" automatically.
4. Press the PROG button on the remote control again to store the station.
5. Repeat above steps 1 to 4 for each station you want to store in memory with a preset
number.
Tuning to a DAB radio station
Repeatedly press the ►►l / l◄◄ buttons on the unit or ►► / ◄◄ buttons on the
remote control to change the frequency until you find the station you want.
Tuning to Preset DAB Stations
• Press the 0-9,10+, PRESET
preset station is displayed. The unit will tune to the selected station automatically.
◦ If the preset number is less than 10, press the number buttons 1-9.
◦ If the preset number is over 10, press 10+ button and press the one of the number
buttons 0-9. (Note! If the preset number over 20, press 10+ button twice and press
the one of the number buttons 0-9.)
/ buttons on the remote control to allocate a number to this
/ buttons on the remote control until the desired
button on the
15