Taga Harmony HTR-1000CD Instruction Manual page 9

Remote Control Overview
Installation of Battery
The first use of remote control, remote control to activate
the battery piece remove protection! It is located at the
bottom back side of the remote control.
Replace remote control battery
1. Loosen the screw on the battery compartment
cover with a screwdriver. Pull out the battery
compartment with your fingernails.
2. Replace a new battery (size 2025) correctly and fully
insert the battery compartment back to the original
position. Tighten the screw with a screwdriver.
Handling the Remote Control
• Remove the batteries if the remote control is not going to be used for an extended
period of time.
• To avoid possible failure, read the following instructions and handle the remote
control
properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under the direct sunlight or near sources of
excessive heat.
• Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner etc.) on
theremote control, as it may suffer damage.
Note!
Remove the battery from remote control handset when it is not to be used for a long
period.
Otherwise it can be damaged due to leakage of battery.
9