Connections - Taga Harmony HTR-1000CD Instruction Manual

Remote Control Overview
Remote Control Operation Range
Point the remote control to the unit no more than 6 meters from the remote control
sensor and within 60° horizontally and 40° vertically of the front of the unit. The
operating distance may vary according to the brightness of the room.
Note!
• Make sure that there is no obstacle between the infrared remote sensor of the unit
and remote control. If you install the unit on rack, etc., the remote controllable range
may decrease depending on the thickness or colour of glass door of rack.
• Do not expose the infrared remote sensor to direct sunlight or other strong light,
such as in verter fluorescent light.

Connections

Caution! Make all connections before plugging the unit into the AC Power outlet.
Connecting the Speakers
Connect your speakers to the Speaker Output Terminals of the unit using speaker cab-
les. Connect each channel (L and R) of the unit with a single speaker.
The output speaker terminal of the unit marked with + (RED color) should be connec-
ted with + (RED color) terminal of your speakers and the one marked with - (BLACK
color) should be connected with - (BLACK color).
Caution! This unit accepts only speakers with impedance 4 ohm to 8 ohm. Connec-
ting speakers outside this range can burn the unit and/or speakers - it may void your
warranty.
Note! Speakers and speaker cables are not supplied with this unit.
10
Right speaker
6m directly
in front of the unit
Left speaker