Hilti DX 5 GR Original Operating Instructions page 26

3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a fastening tool for driving nails, studs and composite fasteners into steel.
When using the tool, always ensure that the correct equipment is used. Fastener guide, piston and fasteners
must be compatible with one another.
3.3 Minimum distances and spacing
3.3.1 Fastening to steel
Always observe the following minimum distances and spacing when fastening to steel:
• The minimum distance from the edge of the working surface to the fastener must be at least 15 mm.
• The minimum center-to-center distance between two fasteners must be at least 20 mm.
• The base material must have a thickness of at least 6 mm.
3.4 Information about the app
To find out more about the app, to download it and start it, scan the QR code in the case.
3.5 Information about the field of applications
Please refer to the Hilti product page for more information about the field of applications.
18 English
Printed: 02.08.2018 | Doc-Nr: PUB / 5433085 / 000 / 01
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
|
¡
Q
W
E
R
T
Exhaust gas piston return unit
Guide sleeve
Casing
Cartridge guideway
Power regulation wheel release button
Power regulation wheel
Display
Pushbutton
Hand pad
Trigger
Operating button
Air vents
Piston rings
Piston
Fastener guide
Fastener guide release button
Buffer
Centering sleeve
Flat brush
Large round brush
Small round brush
2211872
*2211872*