Spectrum Industries 37137 Assembly Instructions

Assembly Instructions Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Flip-up Shelf Assembly
(1) 0119425 (2) 0109646
Worksurface Shelf shim
(2) 056886 (8) #8 x 1"
Shelf bracket PHSM screw
(2) 0135022
Channel bracket

1. Installation

1. Determine the side of the unit the shelf will go on. (Left or right).
2. Align each channel bracket with the leg mounting holes. Figure 1.
(The two sets of 3 smaller holes will face outward.)
3. Install (1) 1/4-20 x 5/8" PHM screw at the top of each bracket.
4. Install (1) 1/4-20 x 2-1/2" PHM screw and Keps nut on the bottom
of each bracket.
1/4-20 x 2-1/2" PHMS
(4) 0100167
8-32 x 1/2" PH
Thread-cutting
screw
(2) 026064
Flip-up Shelf for 3D2GO
1/4-20 x 5/8"
PHMS
Note: Only one flip-up shelf, or one
handle will attach to each side-not
(2) 0190564
1/4-20 x 2-1/2" both at the same time.
PHMS
(2) 0106543
1/4-20 Keps nut
1/4-20 x 5/8" PHMS
1/4-20 Keps nut
Leg
37137
(1) 039622
2" Grommet
1/4-20 x 5/8" PHMS
1/4-20 Keps nut
Figure 1
™
Printer Cart
Phillips
Screwdriver
7/16"
Wrench
Leg
1/4-20 x 2-1/2" PHMS
0190576R1 Page 1 of 2