Connecting The Printer To A Single Computer Using Localtalk - Tektronix Phaser 300X User Manual

Connecting the printer to a single computer using LocalTalk

You can use LocalTalk connectors and cables to connect the printer directly
to your computer, without connecting it to any other network.
Note If your network consists of a single Macintosh and printer and
the cable you are using is not self-terminating, you need to
terminate both ends of the network.
1. Turn the printer off before making any LocalTalk connections.
2. Connect the short cable of a LocalTalk connector to the printer's
LocalTalk port.
3. Connect the short cable of a second LocalTalk connector to your
computer's LocalTalk port.
4.
Connect a LocalTalk cable between the two LocalTalk connectors
you have just attached to your computer and your printer.
LocalTalk®
Input
1 2 3 4 5 6 7 8 9
Reset Extended Skip Metric 1200 Blue Press
Diagnostics * Startjob Paper Size Baud Rate Color Adjust
Run Power Up Run American Variable Off Off LocalTalk™
Status
2
If you have no other connections to make, read ahead to "Turning on the
printer" on page 2-13.
PXi
Serial
(RS-232)
4
2
Getting Set Up
3
8873-21
2-9
User Manual