Tektronix Phaser 300X User Manual page 113

6
Troubleshooting
6-4
Phaser 300X Color Printer
Error codes and front panel messages (cont'd.)
Message
Jam — Paper long
Jam — Paper narrow
Jam — Paper short
Printing
Processing data
Pull ink load lever
Ready
Standby
Stopped — Add < color >
Stopped — Add paper
Stopped — Close rear door
Stopped — Close top door
Stopped — Close waste bin
Stopped — Empty waste bin
Stopped — For hand feed
Stopped — Remove < color > The printer does not need ink of this color. Remove the
System failure. Service
required
Utilities
Wait to add < color >
Waiting for Data
Action
The paper is too long. Remove the jammed paper.
Use shorter paper.
The paper is too narrow. Remove the jammed paper.
Use wider paper.
The paper is too short. Remove the jammed paper.
Use longer paper.
No user action required.
No user action required.
After you add an ink stick, close the ink cover and pull
down the ink load lever.
No user action required. The printer is ready to print.
Press to bring the printer to Ready.
TEST PRINT
The printer needs ink of this color. Add another
ColorStix ink stick.
Add paper, or install the paper tray.
Close the rear cover.
Close the top cover.
Close the waste bin.
The waste bin needs to be emptied, or was replaced
too quickly after being emptied.
Insert paper for manual feed.
ink stick.
Turn the printer off then on again. If the failure persists,
note the code number in the display and call your
dealer, or Tektronix service in the U.S. only at
1-800-547-8949.
The printer is in Utilities mode. You can use this mode
to set the language on the front panel, clean the printer,
check the copy (print) count, empty the waste bin, clean
the fuser, and adjust head convergence.
Wait up to 15 minutes before adding another ink stick.
No user action required.